In the film manufacturing process, tension is a very important quality factor. If in the process of rewinding \ slitting, the guide roller is too lubricated, it will make the film slip, thus forming a series of problems such as uneven film tension and inaccurate overprinting during the rewinding process.

In the past, the way to improve this problem was to remove the guide roller and coat it with a coating to increase the friction of the guide roller to avoid slipping. This method is very time-consuming and laborious, and the cork tape composed of natural rubber and cork can be firmly pasted on the surface of the guide roller of the packaging machine, effectively increasing the friction between the guide roller and the film, and the cork tape will not scratch the film. Make the tension of the film consumed average, improve your production quality.

Application method:

　　1 First, clean the roller surface that needs to be covered with non-slip tape with absolute alcohol, and ensure that the roller surface is lubricated and free of oil.

　　2. Put a shaft on the center paper tube of the whole anti-slip belt to release the whole roll of anti-belt.

　　3 After measuring the circumference of the covered roller accurately, cut the anti-slip tape at an oblique angle, the length of the oblique angle is equal to the circumference.

　　4, quietly peel off the sticker, align the corner of the non-slip tape with the edge of the roller, remove the adhesive on the non-slip tape while rotating the roller, and screw the non-slip tape to the roller On the tube, the anti-slip tape should be straightened evenly when pasting, and there can be no gaps or stacking at the seam.

　　5, after sticking to the end of the roller, cut off the extra non-slip tape, and trim the edge to be the same as the roller edge.

　　6, then wrap the head and tail with narrow tape for a few turns, and firmly adhere to the guide roller of the device.

0010010 nbsp;